drain in a plastic tub
I need to make a drain in a plastic tub for ebb&flow what hardware can I use that is cheap? Any Ideas?
|
I use a threaded 1/2 inch male PVC end stuck through a half inch hole with a sliced end piece of a 1/2 inch female threaded
connector or a gray round type plastic 1/2 nut found in the electric department. Here is one way of doing it. Add plenty of Teflon tape to the threads to prevent leaks. Ron |
All times are GMT -4. The time now is 07:35 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.