This is a Masters Series Advanced Cutting HVAC plasma table. With less than 2 year old Shop Data Software ($7,000). It also has about 3 year old Victor plasma unit that I paid $4,500 for. This table new with software would run $50,000 and this table runs just like it was new. The top servo has also been replaced. We closed a shop down and have this as an extra table but it is ready to go. For $500 additional we will haul it to our shop and wire it all up and teach you how to use it and the software. This table just lifts right up with the fork lift pockets, unlike the other cheap tables out there that are like an erector set. You definitely get what you pay for with a table if you are using it for high volume duct fittings. This table becomes the heart of your shop.

---