Aeroponic Hydroponic Cloning Misters 360 deg. nozzles pack of 10





Description

Here is an auction for a item every do it yourselfer needs to build your own cloner or hydroponic set up. These are 360 degreespray misternozzles, I purchased large qty of these for my own project's. I will sell off some extra's to help out anyone planning to build thier own set up. These are simple to install by drilling hole in pvc pipe or plastic tubing. I have found a 5/32" hole works well. This auction is for10 each of these heads & s&h is$1.75 anywhere in US. Please check out my other Aeroponic auctions for parts, aeroponic kits, cloning kit & more. I will be adding items all the time so check back. I am working on several other hydroponic & aeroponic systems right now, after I have done the builds & testing of those items I will list them for sale here on Ebay. Let me know if you have anything special you may be needing. I have made special tools for cutting out plastic lids for net pots & neoprene inserts. I will gladly build you a custom set up with as many sites as you want, I have built these before & just sent the lid to save on s&h for large item & you can just buy base from hardware store.

Here is some additonal information abut aeroponic cloning in general & hydroponic's.

Check out WWW.Aerocustoms.com for additional information.

Ensuring Your Cloning Success

Homemade Aeroponic cloning systems have been in-effective for many years. Usually, there are expensive pumps to buy, there are always problems with clogging spray heads, and there is always the potential for a homemade water disaster. This brilliant system, designed for cloning, eliminates ALL of those concerns.

Tiny bubbles rushing to the surface pop and throw a very fine mist of water into the air. Clones produce roots more quickly with a series of wet/dry cycles. After two weeks of maintaining the water level in the reservoir, the clones should have roots.

Your cuttings are placed in the netted pots so approximately a 1/2 inch sticks out the bottom, and cuttings are held in place with expanded clay pellets I recommend Hydroton. Or no net pots are required if you use the EZ Clone neoprene inserts included in the kit. The water level is kept 1 inch below the bottoms of the netted pots, which would be only a 1/2 inch below the cuttings. The clones are kept moist by an air pump on a timer, air pump is set to run in cycles continuously for 15 minutes on, than 45 minutes off. Once cuttings are rooted you can adjust timer to longer run times on say ½ hr on & ½ hr off.

How it works:

Success with your Aeroponic cloner starts with cleanliness and the right temperature. Start with clean, room temperature water in the reservoir. Adding a B1 supplement, like Thrive Alive B1, or cloning gel your preference of brand, helps to reduce cutting shock and stimulates quicker and stronger root development. It's easy to adjust this system for Rockwool. Best results by using round Rockwool plugs held in place with some Hydroton (expanded clay pellets) in each netted pot. If you are using larger cuttings just use the pellets alone. Most importantly, keep everything as close to 72 degrees as you can. A small submersible aquarium heater works well or if used indoors room temperature should be ok.

Photo incorporated into this template used with permission of Jupiter Images.

On Jun-10-09 at 19:36:46 PDT, seller added the following information: