I bought these tools all about a year ago. All are in excellent slightly used condition. I made three receivers with them and they turned out beautiful. The bending fixture comes with both the 1mm and 1.5mm punches. I greased it each time and it bent with factory quality results and simple to use with a press. There is a trunion hole drilling fixture for drilling the receiver trunion holes. It is equipped with the 1mm bushing but works fine with 1.5mm too. There is a receiver hole drilling fixture for pre bent 80% receivers. There is the trigger guard riveting jig. There also is the receiver riveting jig with the dimpler. The Toth tool riveting bolt cutter inserts installed on the cutters ( an amazing tool that I built one receiver with). There is the rail alignment fixture. Also I included the 5mm, 7mm drills and reams that are all very sharp. 10mm and 7/32 drill arevery sharp. The barrel gas port drill (unused). and a new 11/64 cobalt drill for drilling rivet holes. As mentioned earlier, these tools are in excellent condition and show little use since I only made a few recievers. They are used and do show some specs of rust here and there from sitting in my garage for a year so please don\'t expect a perfect unused items.

---