ELASTOMERIC RUBBER 5\" PAD DRIVER

CLARKE PART #53534A

FOR CLARKE MODELSUPER Eand V-5 EDGERS

Instructions for replacing the pad, taken directly from the operator\'s manual:

In time the elastomer on the pad may wear or become damaged. To replace, remove pad by placing screwdriver in slot of shaft, grasp pad and rotate shaft counterclockwise. Remove existing elastomer and clean hub throughly to remove old adhesive. Roughen surface of new elastomer to provide good bonding. Apply a good rubber cement to both surfaces and allow to tack. 3M# 1300 rubber and gasket cement is a suitable choice. Apply elastomer to hub and knead throughly. Apply pressure to elastomer and allow to stand over night. Apply a medium strength thread locker to the external threaded end of the shaft. Install belt in grooves on hub and screw down on shaft. Install abrasive retainer on to shaft. Locate a flat surface and tape 80 grit abrasive to surface. Using machine \"dress in\" by sanding the elastomer on the pad. Continue sanding until the entire surface of the elastomer shows signs of sanding. As in operation of the machine, take precautions performing this procedure.

Wecan also order the other pad sizes for the Super E:

• 3\" pad, part # 53533A: $39.50
• 7\" pad, part # 53543A:$49.00

Please use the \"Ask a Question\" link near the bottom of this listing to request either of these parts. We can generally get them to you in two weeks or less.

Wecarry many other parts for yourSuper E, andwe arehappy to special orderothers on request! The majority of parts for the Super 7-R also fit the E. Feel free to ask if you aren\'t sure!

We now carry edger lube. Clarke recommends changing your gearbox grease every 6 months of normal operation.

Need to verify the part number? Wehave a links page of manuals (with parts breakdowns).

FREEFIRST CLASSSHIPPING in US! (See international shipping information below)

AUTHORIZED DEALER

DON\'T SEE WHAT YOU WANT? NEED MORE QUANTITY? If we don\'t have it listed, it may be on order; or it may be an item we don\'t normally stock, in which case we should be able to special-order it. Just use the \"Ask a question\" link near the bottom of the page.

NAVIGATION QUICK LINKS:

Click here for moreedger parts and accessories.

Common parts and accessories which fit more than one type of sander (dust bags, handle parts, wheels and axles, etc.)

Click here for all sander listings.

Tornado Alley Tools offers refurbished floor sanders in excellent condition. Save up to two thirds the cost of a new sander!