This item has been shown 854 times.
For Sale is FLEX-5000A from Flex-radio
This radio is around 18 month old and one owner
It works 100% and come with Fire-wire
cable +DC cable+ CD with manual and Power SDR 2.2.3
Look I would say is 98% perfect.
I own 2 of this radio and
have to sell one.
I will ship worldwide free
with first class mail with tracking number.
Local taxes in buyers country
are not include in offering fee but I will do my best to keep it down.
First picture is from Flex homepage, all other are from this radio.
This radio have general TX coverage over HF band.
Continuous coverage 1.8 to 54 MHz
Power rating HF (1.8 to 30 MHz): 5 to100 watts (100 watts on 6m)More details og FLEX radio are technical details from Flex homepage.
* Frequency range 160m - 6m
* 100W MOSFET PA
* Modes SSB, CW, FM, AM
* Switchable Class A & AB
* TCXO 0.5ppm oscillator
* 11th order front end Rx bandpass filters for each ham band
* Built-in soundcard
* Single Firewire connection (requires Firewire on computer)
* Plug and Play installation
* Balanced mic input
* 3x switchable SO-239 antenna sockets
* 28MHz transverter socket
* Optional Transverter
* Full duplex with optional second Rx board
* Optional Auto ATU
* 3 separate PTT control line outputs
* Self calibration using built-in sweep generator, power sampler & spectrum analyser
* Audio line in and out
The Flex-5000A represents the most advanced and flexible HF transceiver ever offered to ham radio operators. Because of its software design, it has the capacity to be moulded and updated to almost anything you could dream of. TheFlex-5000A offers a level of reception and transmission that provides more performance, more features and more update promises than any other transceiver manufacturer.
The FLEX-5000™ is One of the Highest Performing HF+6m Amateur RadioTransceivers Available at Any Price with 2 KHz Spacing,
Two-Tone 3rd Order Dynamic Range of ~100 dB
The FLEX-5000 series of radios have receiver performance and transmitter capabilities that exceed the $10,000 radios at a fraction of the price. Why spend more money for a traditional legacy radio that doesn't even come close to the FLEX-5000's performance? It's a "no brainer" decision!There is NO need to purchase additional expensive ultra narrow "roofing" filters to achieve world class dynamic range at any spacing. The FLEX-5000 includes at no additional cost an interactive 192 KHz lab grade RF spectrum analyzer with spot-on ClickTune™ capabilities for rapid signal acquisition and "on the fly" Drag-n-Set™ transmit and receive filter capabilities.
Approximately 100 dB two-tone, 2 KHz spacing third-order Dynamic Range (IMD DR3) measured @ 14 MHz+39 dBm 2 KHz spacing third-order Intercept Point (IP3) measured @ 14 MHz123 dB of Blocking Gain @ 14 MHzwith a 2 KHz Offset
-34 dB of transmit third-order IMD Products @ 100 watts PEP on 14 MHz
TCXO for ±0.5 ppm frequency stability.Built In Test Equipment (BITE) allows for self calibration of the transceiver
External Connector for connecting an external high precision clock source for ultra high frequency stability needed for VHF+ operation
A/D converters running at 192 KHz sampling rateIndividual 11th order filters for each ham band. Separate TX and RX Filter Banks.FlexWire peripheral bus provides for unsurpassed external radio integration with third party products and devices
Diversity reception with the addition of the optional independent high-performance second receiver (RX2)Balanced microphone and line level inputsUnbalanced consumer level AF line-in and line-out for connecting external recording equipment or Pactor modems
Three independent fully switchable transmit & receive and one dedicated RX antenna connectors available for the main transceiverRX signal path "loop" for adding receive only devices such as preamps or BCI high pass filters
Three external keying lines that can be sequenced with user definable delays
Optional full-featured 160-6 meter ATU