HIGH CONTRASTCONTROL PANEL OVERLAYAre you tired of struggling to see the controls on your Chrome Panel Blues Jr
in the dim light of your practice room, studio or on stage?
This is the solution.
Our Z/Panel takes the difficult to see rear facing white on chrome panel
and reverses the labels to front facing high contrast white lettering on black.
Our durable laminated vinyl overlay is attached to quality aluminum angled stock.
Installation takes just a couple of minutes and is completely reversible at any time.
\"MORE THAN 300 SOLD\"*PLEASE READ*
You do NOT need to remove the control knobs to install. This is very dangerous
as the pots are soldered directly to the pcb and it can be easily damaged if too muchpressure is put on the shaft.
- Loosen the screw on each SIDE of amp a few turns.
- Remove the six screws on the rear panel, remove panel.
\"DANGER\" Do not touch anything inside chassis while back is removed.
Dangerous High Voltage may be present!
- Loosen the two screws on the TOP of the amp a few turns.
- Insert the Z/Panel over the existing control labels.
- Align the cutout on the Z/Panel with the center screw hole.
- Snug up the two screws on the TOP of the amp (don\'t over tighten).
- 7. Reinstall back panel with the six screws.
- 8. Finally, Snug up the screw on each SIDE of the amp (don\'t over tighten).