Up for sale is a very clean Icom IC-746PRO serial no. 0205267. Cosmetically a 9+ as it shows no scuff marks whatsoever. No exposure to cigarette smoke. All functions work with the exception of the electronic keyer which produces dashes only no dots. You\'re guess is as good as mine. I\'ve had this rig over two years and I normally don\'t work CW so I only found this fault just recently.offer for what its worth, .Unit comes with original carton and packing materials, microphone, power cable and owners manual which is in very good condition. As with all used electronics this item is sold AS IS. Asking $40.00 for shipping to CONUSsince its pretty heavy and it will be professionally double boxed at the UPS counter and sent by Ground Service with insurance.Beloware the specs and thanks for looking :)

Following on the success of the Icom IC-746, the Icom IC-746 Pro covers 160-10 meters plus 6 and 2 meters all mode. 100 Watts of output is available on all bands - HF, 50 MHz and 144 MHz, making the IC-746 Pro a practical choice for all-around base station use. The die-cast aluminum chassis and a large cooling fan help to stabilize the PA circuit, providing 100% full duty cycle operation. The new Pro version features 32 bit floating point DSP and 24-bit AD/DA converter. This combination dramatically improves receiver performance providing ultra wide dynamic range and good third order intercept point. An there are NO more expensive optional filters to buy. The digital IF filter allows your to select 51 filter bandwidths. There are three user selectable filter memories per mode. Soft and sharp filter shapes can be selected in both SSB and CW modes independently. You can also change the settings on the fly and compare! For repeater operation theres is a built-in tone encoder and decoder with 50 CTCSS and 108 DTCS based tones. There is even a built-in Baudot RTTY demodulator.

It has 100 alphanumeric memories, digital RF speech compression, spectrum display, Manual and Automatic Notch, digital Twin PBT, Noise Blanker, CTCSS encode/decode, APF, two stage preamp, automatic antenna tuner and electronic keyer. A built-in automatic antenna tuner operates on the HF bands plus 6 meters. The 746 Pro requires 12 VDC at 23 Amps. The IC-746 Pro comes with HM-36 hand mic, spare fuses, OPC-025 DC power cable and key plug. 11.3 x 4.8 x 12.5 inches. 20 lbs.
See the May 2002 issue of QST for a great review of this radio. Features

• Spectrum Scope
• 102 Memories
• RIT/XIT
• Digital Noise Reduction
• Manual and Automatic Notch
• Digital Twin PBT
• Dual Display
• 100 Watt Output
• 40 Watt Output (AM)
• Digital RF Speech Compressor
• Microphone Equalizer
• Monitor Transmit Audio
• SWR Plotting

• Built-in Automatic Antenna Tuner 180-6 Meters
• Full Break-In CW
• SSB/CW Synchronous Tuning
• 100% Duty Cycle
• Rx Antenna Jack
• 32 bit DSP
• 1 Hz Readout
• 4 Channel Memory Keyer
• RF Attenuator 6/12/18 dB
• RTTY Demodulator
• CW Pitch and CW Reverse
• Adjustable Transmit Bandwith
• Triple Band Stack Registers