Ingersoll Rand SSR-EP25SE rotary screw air compressor. 25 HP 3 phase 230/460 V. Approximately 44,000 hours. I can put it under power and test run for a successful buyer at pickup. I have a machine shop. I have a dozen cnc\'s, a lot more manual equipment, and some stamping equipment. This compressor did fine running a dozen cnc\'s. When I turned on the blast cabinet it was all over.. My new compressor is a 40HP, with a 60HP backup. This one is just too small for me. Its rated at 94 CFM, which means if I cap the 1 inch npt outlet, drill a 0.250 inch orifice, it should run fully loaded but maintain pressure. It does this. Tested shortly before I took it out of service, the air end is in good condition, near new drive belts. It will need an oil/ filter/ separator change, but I would fire it and warm it up good first. It has been in storage a couple years, but I guarrantee it to not be doa. Ask any questions you want to know. Free onboard. estimated ship weight 1000 lbs. free local pickup. If I have to crate it to ship it the crate will cost $400.00. local pickup only was the easiest to list ship option. email to discuss your needs.and also, this compressor has no tank. It can run with the motor constant on loading and unloading the air end, or it can modulate, starting and stopping the motor when the air is not needed. Its all in the set up in the lcd panel.

---