DON\'T BE FOOLED BY THE IMPORTED COPYCAT IMITATIONS, THESE ARE THE ORIGINAL MADEIN THE USA VE REFIT BOARDS, WE HAVE BEEN SELLING THESE FOR OVER 15YEARS: You are offerding on (1) of our Dynaco (registered trademark) PAS preamplifier PC-5A stuffed refit boards. The PC-5A replaces the original PC-5. THIS LISTING IS FOR THE PC-5A STUFFED BOARD ONLY. This was engineered to be a restoration board and as such, follows the original 12AX7 circuit faithfully, including wire hole layout and numbering. THIS IS NOT A MODIFICATION. Board is made of 0.062\" FR4 material, is doublesided offering plated thru-holes and solder rings/pads on the top side. Board also went through a solder reflow process. There is no silkscreening on this board. Components: ceramic tube sockets, metal and carbon film resistors, silver mica capacitors, and metal film tubular capacitors. Purchaser must have a copy of the Dynaco PAS manual for installation procedure (we DO NOT include the manual with the board). In general, simply unsolder and remove your old board, install the new board and solder the wires back into the appropriate holes. Please note, we are responsible for the stuffed board only, and once soldered into a preamplifier, all warranties and gurantees are voided except where the quality of the board or components is found to be faulty. Thanks for looking and be sure to check out our other store listings and sales as well. SPECIAL OFFER - FREE brand new VE Tube Pin Straightener (Made In USA) for all orders over $250!!! Works with 7 pin miniature, 9 pin miniature, Magnoval, Novar, and Compactron tubes. Also available for individual sale, please visit our store and search for Tube Pin Straightener.

---