OmniTurn GT-75 Lathe
About OmniTurn
OmniTurn has been building precision CNC turning machines since 1987, beginning with CNC conversion kits for chuckers and toolroom lathes. We have always used the highest quality ground ballscrews and linear guides available. The machine base, slides and tooling plate are precision-machined in America
In 1994 we began producing the OmniTurn GT-75. The GT-75 is a fully enclosed slant-bed turning center with American-made high-precision spindle,pneumatic collet closer, flood coolant, and work lamp.
In 1998 we introduced the OmniTurn GT-Jr. The GT-Jr has the same rugged and precise base, table and spindle as the GT-75, but without the enclosure, which allows for very fast change-over and setup.
OmniTurns are fast, precise and affordable. They are also reliable, easyto operate and inexpensive to maintain. There are thousands of OmniTurns in use throughout the country earning a profit for large corporations as well as \'garage-shops\'.
We are able to offer this Brand New GT-75 for only $32,995.
More information is available here.
This machine was used only for software development and customer demonstrations.It is built entirely at our factory in Oregon. Easy setup! The GT-75 is shipped in a wooden frame as illustrated, for easy pallet-jack maneuvering into place in your shop.Air requirements are minimal: less than 3cfm at 80psi. Electrical power requirements are 220vac single or three-phase, 25 amps. The machine does not need to be bolted down. Leveling pads are included; simplyadjust each pad to stabilize the machine. You can set up your OmniTurn GT-75 with no special tools, and be ready to run parts very quickly.
Free telephone support and service weekdays 8am - 5pm Pacific Time [phone removed by ].
Full one-year warranty on all parts.
OmniTurn GT-75 Standard Features Include:
- Travel in X: 12\" Travel in Z: 9\"
- Accuracy of slide travel: .0001\"
- Resolution of slide travel: .00005\"
- 5HP spindle drive
- PC based control; holds thousands of programs
- Standard G- and M- Codes
- Gang tooling - 1/4 sec between tools
- Pneumatic Collet Actuator; 5C Spindle
- 1/8hp Flood Coolant System
- 75 degree slant-bed lets chips fall away
SHIPPING
- Buyer will pay ACTUAL COST by truck to anywhere in the continental US.
- OmniTurn Factory will crate the machine and arrange shipping at no extra charge.
- Call [phone removed by ] for shipping estimate to your location.
PAYMENT
We will accept Cashier\'s Check, Money Order or Bank Wire Transfer for payment .