This is a Owatonna Mustang 310 skid loader. This is one of the smallest loaders made. It has a 14hp single cylinder Onan engine with a hydrostatic drive. This is the same loader as a John Deere 60 which was also manufactured by Owatonna for John Deere. The motor starts and runs well, it is not the original one that came in the machine, this one only had around 200 hours on it when installed and only has a couple hours on it since then. I did just put a new ignition coil in the motor. I also put new seals in both lift cylinders and the tilt cylinder. The tires are decent some are in very good condition and one looks to have had the sidewall rubbed against something as can be seen in the pictures. It has a decent 32\" bucket and a lift capacity of 550 pounds. There is no rear door on the machine, I\'ve had 3 of these machines and they were all missing the rear door, they were usually taken off so they could fit in small places and then seemed to get lost. I can make a simple rear door for you if it is needed. This is a sale and will sell to the highest buyer.Payment is to be in cash at the time of pickup. You can pay through paypal but if this is your payment option then you will have to pay the paypal fees if it sells for more than 5,000. I believe they are 3 or 4 percent. Payment and pickup is to be made within 7 days of the end of the sale unless prior arrangements have been made and the loader is paid for in full. Thanks
Please do not offer if you have no intentions of following through.The Skid Loader is for local pickup only in Oxford Junction, Iowa 52323 or I can have it delivered for 1.00 per loaded mile from Oxford Junction, Iowa to your location with the mileage to be determined by mapquest or I can assist you or your shipper load the machine for transport. I do have a forklift on site as well and can load this onto most trailers. If shipping is needed than the full purchase price plus the delivery fee must be paid for prior to delivery. I can store this loader for up to 6 months for free as long as it is paid for within the 7 days If you want to see the machine in person before offerding contact me and we can make arrangements, Thanks

---