This item has been shown 2846 times.
COMBINED SHIPPING FOR MULTIPLE ORDERSPLACED ON THESAME DAY.
$6 shipping to all United States zipcodes, including Guamand US Virgin Islands, $14 to Canada
No matter how many you buy, one flat rate price for shipping!
What is a battery desulfator you ask? It is an electronic device that cleans the internal battery plates to remove the lead sulfate that builds up on poorly maintained batteries. This lead sulfate(that white residue)will form on the batteries internalplatesand greatly reduces the capacity of a charge on a battery. By restoring the lead sulfate back into the acid solution you can greatly extend the life of the battery by many years. Our product is designed to be left connected "full-time" to the battery and will provide many years of maintance free operation.This product will work on all types of lead based batteries, including sealed lead acid (SLA), and the more common flooded lead acid (deep cycle or automotive).It is recommended that a small trickle style charger in the 1-2 amp range be used when recovering a battery with heavy deposits. Largehigh current, bulk rate chargers, will quicklycause heat build up in the battery and could boil the acid causing a very dangerous condition.For large battery systems, like that of a golf cart or solar battery bank, one desulfator is required per battery.This product will desulfate batteries ranging from 1 amp hour to 1000 amp hours. Due to the wide range of battery types and post configurations, we do not include ring lug terminals with our product. These ring lugsare available at most automotive or marine centers in sizes to fit your application.Our productis 100% made in the USA, yes even the labor. Thank you for taking the time to read about our product. More picturescan be seen at our website: www.wizbangplus.com
Battery BD-12 series
Proven Circuit Design
Surface Mount Technology PCB
Strong ABS Enclosure with Mounts
Large Input Voltage Range
Low current draw CMOS Components
100% Made in the USA
1.) The Wizbangdesulfator should be installed as close as possible to the battery terminals. (within 14 inches, or 35 cm)
2.)You many trim the wire leads back with wire cutters/strippers to work best for your application. (shorter is better)
3.) Install the Red wire to the positive (+) terminal on your 6, 8 or12 volt battery.
4.) Install the Black wire to the negative(-) terminal on your 6, 8 or 12 volt battery.
5.) Verify that the red LED is on, you might also be able to hear a “buzzing” noise.
6.) The best results for recovery will occur within the first 4 weeks.If left connected longer,desulfating will continue but at a slower pace.
7.)The Wizbang desulfator has a built in auto ranging feature that will automatically adjust for different battery voltages.
8.) Your done. J Happy desulfating.
NOTE: If you connect the wires incorrectly the internal fuse will blow. Pry the back cover open and replace the fuse with the same type GMA 6amp with afast blow rating.
INPUT 4.5Vdc – 16Vdc
OUTPUT VOLTAGE 60V (pk-pk) inductive (10uS pulse every 1mS approx.)
RATED 45mA Average @ nominal 12Vdc input.
FREQUENCY RANGE .8 – 1.2 KHz. Temperature and input voltage dependant
REVERSE Internal Fuse provides limited protection
WORKING 0C ~ +60C (+32F ~ +140F) (+273K ~ +333K)
WORKING 20 ~ 90% RH non-condensing
STORAGE -20 ~ +85C (-4F ~ +185F) (+253K ~ 358K)
VIBRATION 10-500HZ, 2G 10min./1cycle, Period for 60min. Along X,Y,Z axis
WITHSTAND I/P – O/P: 3KVAC
ISOLATION I/P – O/P: 100m ohms / 500Vdc
The manufacturer reserves the right to change these specifications at any time without notice.