User\'s guide [ EN ]
User\'s guide [ ESP ]
User\'s guide [ PL ]
Oryginal (from the Proma-Elektronika company)
Device for professional use ( 100% duty time )100% satisfied customers
We accept returns if you not satisfied ( full payment return )
User\'s guide, invoice and warranty include.Ready for use!
Very easy to install and configuration
The device works with any plasma cutter
You don\'t need a voltage divider or additional componentsFor example this device works with MACH2, MACH3, EMC1
or any program / system that accepts THC UP/DOWN signals.The device is a modern analog - digital controller of height of a plasma torch over a cut material. It is based on analysis of change of voltage generated by a source of plasma.Simplified block diagram:
Specification:
Supply voltage (V) 7 – 35V DC
Input LOW voltage 0-10V DC (from cuter voltage divider 1:50)
Input HI voltage 20-300V DC
Ability of HV/HF ionization voltage suppressing 30kV
Ability of HV/HF ionization frequency suppressing >100kHz
Duty cycle (%) 100%
Duty cycle of HV / HF suppression (%) 100%
Rated max. load 1,25A / 60V DC
Relay reliability (minimum amount of cycles) under load of 5V / 10mA : 500*10^6
Degree of protection of enclosure IP IP20
Weight (g) 180g
Dimensions (width*length*height) 33*89*65
Mounting DIN 35 rail
country of origin : POLAND
Example for MACH3 DEMO configuration :
This device connect to your system the same as home switch, e-stop etc, the connect diagram is dependent on your system.
Before buy you can test your system with switches connected to your system - you simulate the thc up/down signals and make sure that this device will work with your system properly.
Example for Plasma-Voltage connection
PLASMA CUTTER WITH VOLTAGE DIVIDER 1:50 OUTPUT :
PLASMA CUTTER WITHOUT VOLTAGE DIVIDER OUTPUT :
Example for connection ( arc ok signals isn\'t require )
Example for Gecko540 driver connection
Clients VIDEO (old version without 1:50 divider input)
Worldwide support via e-mail or MSN
Shipping from Polish to European Union : Registered mail (tracking).
Estimated delivery time 3-7 business daysShipping from Polish to Outside European Union : Registered mail (tracking).
Estimated delivery time: 5 - 15 business days ( rarely >10)Attention: I send in the day of pay or next bussines day (rarely max. 2 days).I can send DHL WORLDWIDE - Estimated delivery time: 2 - 4 business days.