SpeeCo or HuskyPump Mounting Bracket

Part# 400812

This pump mounting bracket fits most 5 to 6 hp gas engines with threaded holes in the side of the engine.

Below is the approximant dimensions of the mounting bracket.

The larger octagon side of the bracket the boles hole are approximately 2 ” center to center of the bolt holes The holes are approximately 5/16” in diameter. This side this what bolts up to the motor.

The large hole in the octagon shape side is approximately 1 ¾” in diameter. This is were the motor shaft goes through.

The pump side is approximately 2 9/16” center to center of the bolt holes with holes approximately 5/16” in diameter. This is the side that is square looking.

The length of the bracket is overall 4” long.

The bottom of the bracket opened to give you access to install a love joy coupler or the coupler of your choice.

All measurements are a approximate measurement done with a tape measure. The bracket may be returned if it does not fit but the return shipping will be a the buyer expense. I will refund price of the bracket but not the shipping cost that was involved in shipping out the bracket.

Shipping to Alaska is extra.