I have a Woodmaster planer/molder model 712 with a Dual Routing attachment. It also comes with the pro pack kit. I will list below Woodmaster's description from their website. In addition to machine itself I have two sets of planer knives, one set of Log Siding knives (which will make log siding in one pass using softer woods such as pine, cedar, poplar), two sets of tongue and Groove router bits (one set is basic tongue and groove and the other creates a V-groove), one V-groove molding knife, and two pair of saws (2-5.5" blades and 2-6.5" blades). I have over $3500 invested and only used a couple of weekends. I'm only asking 2,750. I made some log siding and it would profile the log and tongue and groove it in one pass. Made 1x6 v-groove paneling also in one pass.

Thanks

Model 712 INCLUDES 5 H.P. 220-Volts, Single Phase 60 cycle 30 Amp. motor that drives the planer head. One magnetic push button motor start switch. 1/3 H.P. D.C. motor that operates the feed system with a 110-volt variable speed control switch. 1-Set of 3 high speed steel planer blades mounted in a precision steel 3-knife head. This head can also be used for mounting molding knives. One set of steel in-feed and out-feed extension tables. One each magnetic depth of cut scale. One WG1 Knife Set Gauge, Operators Manual

Pro-Pack
1each 712 Accessory Shaft used to mount Saw Kits. Single Knife Holder and Drum sanding kit.
1 each 700C Single Knife Holder a fast set up for running Profile Knives up to 3-1/4
1 each 712D Drum Sanding Kit
1 each 712NH Dust Chute with 4-inch Diameter Exhaust
1 each 712PB Super Slick Bedboard with two guide rails and mounting hardware.
2 each 700SK 5-1/2 inch Rip saw blades with locking collars

Adding the Woodmaster dual router attachment turns your Model 712 Molder into a three side molding system.

When making flooring the poly guide table and angle guide tracks allow positive tracking guiding the piece thru the machine so the up side of the piece can be milled. As the piece exits, the external feed roller assembly that mounts to the laser-cut extension table continues feeding the piece allowing the two Milwaukee 3.5 H.P. routers to go to work creating your T&G cut.

The bottom router is stationary and the top router is mounted on a table. The top router is positioned by turning an adjustable screw feed controlled by a heavy duty hand wheel. Material 2-inch to 7-inch wide can be tongue and grooved in one pass.

Your Double Router System is equipped as follows:
Two Milwaukee 3.5 H.P. 120-volt 15-amp. Milwaukee Fixed Base Routers
One Set of Caroffere Tongue and Groove Router Bits for ½-inch to 1-inch thick material
One Poly Guide Board designed with counter sunk guide rail alignment mounts
Two Poly Face aluminum guide rails
One Laser-Cut Double Router Extension Table
Two-Inch Dust Port Mounts for each Router
Power Feed Roller Assembly
Top Router Adjustment Table with Hand Wheel Adjusting Screw
Owner Manual

---