Offering a circuit extender board for the Yaesu FT767 Transceiver Transverter Module in KIT FORM.
Offering a circuit extender board for the Yaesu FT767 Transceiver Transverter Module in kit form. Buyer to solder the edge connector and apply the heat shrink tubing that takes about 15 minutes. This board is used to extend the plug-in boards so they can be serviced and/or repaired. This board is close in fit, form and function to an original Yaesu extender board.When used with this extender the transverter module will connected to the transceiver and be ready forvoltageand or o-scopesignal probing.
A heat shrink tube covers the traces where they will exit the radio to preventthe traces from touching the side of the slot.
The offering includes the following board:
One 14X 2 (14 conductors on each side for a total of28 conductors)
NOTE: I can custom make almost any extender board. With basic information about the extender you need I can program the automated CNC machine I have to produce what you need. I do not charge extra for customizing a board or set of boards needed to service most radios and test equipment. With basic information from buyers I produce a set to sell to them through and then offer the same extenders to other buyers on . If you have an idea for an extender board or extender board set you or others need please contact me so I can make up a design and offer it on .
Thank you and best regards
John Nery Buyer to solder the edge connector and apply the heat shrink tubing that takes about 15 minutes. This board is used to extend the plug-in boards so they can be serviced and/or repaired. This board is close in fit, form and function to an original Yaesu extender board.When used with this extender the transverter module will connected to the transceiver and be ready forvoltageand or o-scopesignal probing.
A heat shrink tube covers the traces where they will exit the radio to preventthe traces from touching the side of the slot.
The offering includes the following board:
One 14X 2 (14 conductors on each side for a total of28 conductors) traced board and edge connector.
NOTE: I can custom make almost any extender board. With basic information about the extender you need I can program the automated CNC machine I have to produce what you need. I do not charge extra for customizing a board or set of boards needed to service most radios and test equipment. With basic information from buyers I produce a set to sell to them through and then offer the same extenders to other buyers on . If you have an idea for an extender board or extender board set you or others need please contact me so I can make up a design and offer it on .
Thank you and best regards
John Nery WA1ESO
401-624-4576
