Great tool to have for punching holes in sheet metal. I use it to punch spot weld holes and it works good. Can't beat the price either.
Verified purchase: Yes | Condition: New
This tool has one job, to punch holes. It doesn’t do that. The jaws are visually misaligned which causes the punch to enter material at an angle. This makes for a sloppy cut that is more jagged than using a drill in thin metal. If the punches were sharp and the jaws aligned it would likely work. Jaws cannot be adjusted. Essentially a waste of money.
Verified purchase: Yes | Condition: New
The 1/8" punch will not fit standard 1/8" pop rivets. It makes a hole that is to large
Verified purchase: Yes | Condition: New
I was looking for replacement dies for my very old punch exactly like this. I would have been happy with this cost for the dies only. However, there are Metric, and so are not exactly the same as the fractional size.
Verified purchase: Yes | Condition: New
I had one before. Hard to find. Great price and value
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Punches
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Punches