Plant Looking good there Parabox .
Where you buy the CREEs at ?
I'm thinking of buying CREES for my set-up but they will be the solderless type. I've done soldering before (non-related to grows) and find it very tedious
plus nerve racking so the snap on connectors are so easy and less time consuming.
I been looking at Rapidled.com.
Check out the prices and let me know if you found them cheaper as I'm not locked into any website when it comes to my $.
Thanks
Quote:
Originally Posted by Parabox
Here is an update. I believe I have set these plants back a bit because I did not have any support for them. I noosed them with string and they seem to be growing and thriving again.
I had too many plants for the light I had hooked up. The LEDS were too close and left just a spotlight of light. The new light shown here is three times as wide with the LEDs set wider apart to create a bigger footprint of light. 20 Cree XTE LEDs are wired in serial here. This setup has 6 cool white, 6 warm white, and 8 nuetral white XTE/XPGs being run off a single 100 watt driver. This time they are being driven twice as high at 1400 mA for a brighter light. The lights cover the entire light spectrum and hit all the important wavelengths. The tomatoe flowers are blooming but I have not pollinated them yet. Not sure the point of smurfs comments as it is already blooming.
I am finding what others have commented on however. The effective throw of the LEDs seems to be about 18-20 inches. I am getting a lovely dense canopy within 18 inches, but more sparse foliage below that. I am thinking about building a reflector shield with more leds built in to the sides to throw light into those lower areas.
|