Hydroponics Online Home Home Store Blog Forums FAQs Lesson Plans Pictures

Go Back   Hydroponics Forums Discussions > Hydroponics Discussion Forums > Your Hydroponics Setup

New setup for my tomato's


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 02-14-2010, 11:07 PM
GpsFrontier GpsFrontier is offline
Senior Member
 
Join Date: Mar 2009
Location: Lake Havasu AZ.
Posts: 1,855
Default New setup for my tomato's

Well this is actually a continuation of another thread, but I thought I would start a new one sense it is a new start for my tomato's. It is basically the same setup with a couple of modifications. The geothermal reservoir is the biggest one. It is going to get too warm to keep the nutrient s outside soon, so I built the geothermal reservoir to keep them cool. Basically it consists of a 32 gallon trash can that's permanently in the ground. With a removable 20 gallon trash can inside of it, and buffer between them. The buffer water is to allow better transfer of heat from the nutrient solution (in the 20 gallon trash can) and the ground, but still allow the nutrient reservoir to be easily removable for maintenance.

First I had to dig the hole, that was a real feat. It took me 4 days, and I still wanted it 6 inches deeper. But I ran into 2 rocks I just couldn't get out, so I settled for 30 inches instead of 36 inches deep. Once I had it dug I sifted the unearthed soil to get the rocks out to back fill it with. That way it wouldn't damage the reservoir as it settled back down. The pile of dirt next to the wall behind the hole is the sifted soil. The dirt in the 5 gallon bucket is the sifted soil before I put it on the pile. The green bucket next to it is the rocks that I got out of just that one 5 gallon bucket of sifted soil. The hand scoop I already had from metal detecting. I was going to get a spaghetti strainer from the dollar store before I remembered I had it.

I had to cut the handles off the 20 gallon reservoir so that it would fit nicely inside the larger one. Then I cut two circles of 2 inch thick Styrofoam, one for each trash can. this keeps the heat out from above ground. Then I made a handle for each Styrofoam insert to easily take them out. To make all the holes line up for the over flow tube, I simply places the 2 Styrofoam inserts in place, then the trash can lid. I took a thin metal rod, heated one end and then stuck it straight down through all 3. That way I knew that they would all line up. Then I just made each just large enough for the tube to go through.

The blue things around the over flow tube is just a home made washer, made out of a small piece of thin insulating foam that I already had, and a rubber band to hold it in place. That way I can set it in place, then put the trash can lid on top without needing 3 hands. The blue insulation foam around the 2 gallon buckets I already had (the same I used on the over flow tube). The pipe insulation on the P.V.C. tubing, I also already had. I will also be putting pipe insulation on the black 1/2 inch vinyl tubing from the pump to the P.V.C. in the future. That's basically the new setup.

P.S. I will still be finishing the reservoir off by placing something like bender board (for garden edges, only 12 inches wide) in the ground around the trash can. Three to four inches deep, and about 8 inches above ground. Then I will place a mound of dirt all around the outside of it. That will be a 8 inch high mound of dirt all around the reservoir. This will keep rain water from overflowing into the reservoir and flooding it. I will also be placing a flat board over the top of it, this will help keep it cool, and the warm air and rain out. As well as adding a few inches of depth to the system.

The large trash can was $10
The small trash can was $12
The Styrofoam sheet was $6
Digging the hole, Priceless

Attached Thumbnails
Click image for larger version

Name:	100_9529.jpg
Views:	889
Size:	97.7 KB
ID:	585   Click image for larger version

Name:	100_9530.jpg
Views:	836
Size:	97.5 KB
ID:	586   Click image for larger version

Name:	100_9526.jpg
Views:	832
Size:	97.4 KB
ID:	587   Click image for larger version

Name:	100_9537.jpg
Views:	800
Size:	97.8 KB
ID:	588   Click image for larger version

Name:	100_9536.jpg
Views:	799
Size:	89.5 KB
ID:	589  

Click image for larger version

Name:	100_9534.jpg
Views:	817
Size:	89.0 KB
ID:	590   Click image for larger version

Name:	100_9535.jpg
Views:	813
Size:	93.7 KB
ID:	591   Click image for larger version

Name:	100_9540.jpg
Views:	809
Size:	97.5 KB
ID:	592   Click image for larger version

Name:	100_9541.jpg
Views:	852
Size:	98.0 KB
ID:	593   Click image for larger version

Name:	100_9542.jpg
Views:	841
Size:	97.9 KB
ID:	594  

Click image for larger version

Name:	100_9547.jpg
Views:	842
Size:	97.2 KB
ID:	595   Click image for larger version

Name:	100_9545.jpg
Views:	852
Size:	97.1 KB
ID:	596   Click image for larger version

Name:	100_9546.jpg
Views:	828
Size:	97.3 KB
ID:	597   Click image for larger version

Name:	100_9539.jpg
Views:	804
Size:	96.8 KB
ID:	598   Click image for larger version

Name:	100_9538.jpg
Views:	852
Size:	96.5 KB
ID:	599  

Click image for larger version

Name:	100_9553.jpg
Views:	929
Size:	98.6 KB
ID:	600   Click image for larger version

Name:	100_9554.jpg
Views:	904
Size:	99.4 KB
ID:	601   Click image for larger version

Name:	100_9555.jpg
Views:	881
Size:	98.9 KB
ID:	602   Click image for larger version

Name:	100_9556.jpg
Views:	865
Size:	99.4 KB
ID:	603  
__________________
Website Owner
Home Hydroponic Systems

Last edited by GpsFrontier; 02-15-2010 at 06:53 PM.
Reply With Quote
 

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 10:03 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.