Home | Store | Blog | Forums | FAQs | Lesson Plans | Pictures |
|
|
Thread Tools | Display Modes |
#41
|
|||
|
|||
Ya, first time is always the hardest... for some at least :P
But I'm learning. This system might end up being one time use if I cannot find a way to clean it if that whole root system happens like it did to you. Would I be able to bleach it? There is not much I can do to change it now. In September I will build a system with 3 or 6 ft pipes for my basement. I will do it so it's just one single flow, not multiples. Seems like it would be the easy way. I won't glue it next time, I really regret doing that. Silicone might of been better? I have 4 months to learn more about hydroponics, so I will just keep watching videos and reading stuff. Also, yes, a water line for each pipe. Right now it's only on two pipes but I'm going to add the two more because if I lower the level too low then barely any water flows through it. But anyway, I've learned a lot from building this. I can see what I did wrong, and what I should of done, etc.. Now all I gotta do is hope my plants will grow in it. |
#42
|
|||
|
|||
Update:
As of today the system is currently unusable. The pipes are bowing pretty bad, it might be the heat. They are bowing upwards, and downwards. Edit: Looks like this system is junk, sadly. I will see if I can do something else with it. Last edited by FalseFlash; 05-10-2013 at 03:39 PM. |
#43
|
|||
|
|||
If you cut the tubes that hold the plants from all the connectors, you could still use them. I attached some pictures of some systems to give you some ideas. The last two drawings are of concept we plan to build ourselves in the near future.
|
#44
|
|||
|
|||
Thanks, I plan on doing the snake shape.
|
#45
|
|||
|
|||
GPS, that's a nice site. I really like the aeroponic tower with wheels.
IAGR66 tower garden aeroponics System, View vertical garden Aeroponics System, CWTOM Product Details from Cwtom Electrical, Metal & Plastic Factory on Alibaba.com I've been trying to build 1 the last 2 years and just haven't been able to perfect it. |
#46
|
|||
|
|||
Stan, do you have any pictures of what you have built, and/or how you constructed it?
|
#47
|
|||
|
|||
I also looked at those but could not figure out how to connect the tower to the base. The one for purchase is a moulded plastic piece.
|
#48
|
|||
|
|||
I will take some pictures over the weekend of what I have. Like I said earlier I wasn't able to perfect it. Even though I had sprayers at 2 different levels inside the tube to much water would leak out of the holes I drilled. I think I might have a way around it and will try it out over the weekend.
|
#49
|
|||
|
|||
I don't know if you have seen the drawing's I have posted before about a similar setup. So that is why I asked if you had any pictures. To see if what you built was similar to my ideas. If not, I may be able to help with some of my ideas, as well as with the construction methods I had in mind. If you don't start a new thread about it before I do, I'll post the drawings I have in a new thread about it soon.
|
#50
|
|||
|
|||
Kratky
Try looking on youtube at the Kratky method. It's cheap, set it and forget it,
and totally off grid. |
#51
|
|||
|
|||
I will watch it later, thanks!
|
Bookmarks |
|
|