Temperature Controller for Heat, Refrigeration and Cooling

HRC-15 Specifications

· 110 VAC rated for continues 15 amp operation with built in over current protection

· Aluminum box construction

· 14 gauge heavy duty power cord (UL listed)

· Heavy duty grounded Pass & Seymour receptacle (UL listed)

· 110 volt digital controller that displays temperature in Celsius. (CE marking) Celsius to Fahrenheit conversion chart and manual included.

· -50 C to +110 C temperature range (-58 F to +230 F)

· Minimum of 1 degree on/off temperature differential. This differential can be adjusted between 1 C to 15 C. (The manual refers to this setting as Hysteresis).

· Can be used in the heat or cooling modes. Commonly used for distillation, fermentation, domestic freezer, water tanks, refrigerator, industrial chiller, boiler, steamer, industrial equipments and others

· Off time delay for use with refrigeration system (prevents short cycling of refrigeration compressor)

· Programmable upper and lower temperature limits

· Temperature calibration can be adjust -5 to +5 degrees C

· Probe Options – Water proof epoxy sealed OR 3/8” custom stainless steel bulkhead fitting with stainless steel bonded sealing washer. This bulkhead sensor was designed and successfully tested in round stainless steel pots as small as 2 gallons. It may even work with a tighter radius, it just hasn’t been tested.

· 25 amp Solid State Relay (CE marking)

· The controller, over current protection, wire for temperature probe and receptacle are sealed to the box to help prevent incidental water intrusion. (This unit is not 100% seal and care should be taken to keep it dry)

· The box is mounted on rubber feet to aid in cooling and reduces slippage.

· Designed and built in the USA.

sale is for controller, instructions and your choice of probe. Extra probe is available at an additional cost. Custom probes available as well. Contact seller for price and availability. We proudly design, build & test these units in Wisconsin. There are extensive research hours on using this controller for distillation. 1 pictures showthe unit hooked up to my um.....Ethenol fuel still (not included) and it works awesome!Please contact us with questions before and after the sale as your satisfaction is our #1 priority. I am using my personal account to show you ourdedicationand belief in this product. Shipping is free to the lower 48 states only. Returns: We test this product before we ship but do realize that sometimes things happen. Please contact us within 14 days if this product does not work. If we can\'t fix via email or over the phone (it might be aprogrammingissue)we will gladly replace or repair. I can\'t say this enough that your satisfaction is our #1 concern but we need to know about problems if for viewing our controller and we look forward to doingbusinesswith you soon!