Daewoo Puma 230MB turning center, new in 2002, serial no. P23M2602. Fanuc 21iTB control. True C axis spindle w/ live tool turret, programable tailstock, powered tool presetter, parts catcher, Royal mist collector
Condition of this machine is amazing, not one drop of touch up paint, all original. Previous owner was small prototype race engine shop. Notice even the chip pan still has all the paint. Axis and spindle quiet and smooth as new machine. Spindle motor rated for 20 hp. Main input is 230 volts, 3 phase
Tooling includes S26 collet head as shown, plus 20 Hardinge S26 collet pad sets, ten inch 6 jaw manual chuck plus your choice of either 8 inch MMK hydraulic or 7 inch Kitawaga hydraulic chuck (none of the chucks have adapters to the A2-6 spindle and the 6 jaw has only one set of jaws) Also 4 live tool holders (including one new in box), straight tool holders as shown on turret, and Royal live center. Daewoo manuals as shown and original inspection sheets plus parameters on CD.
Can prepare for shipment and load at no charge. $1,000 deposit via Paypal is ok but balance must be paid by company check or bank wire. Contact with questions or to arrange under power demo. See my responses for indications I tell it like it is.
Video- Over Bed: 21.7”
Swing Over Carriage: 15.4”
X Axis Travel: 8”
Z Axis Travel: 22.8”
Max Bar Capacity: 2.5”
Max Turn Diameter: 11.4”
Spindle Nose: A2-6
Spindle Speed: 45-4500 RPM
Spindle Motor: 20HP
Rapid Traverse Rates: 1,200 X and 945 Z IPM
Turret Stations: 12