Great, lightly used BeckerOilLess Vacuum Pump: VTLF 250 SK with Lincoln 10HP3 phase motor. Wired at 230V, it uses 28.9 Amps. Wired for 460, it\'lluse 14.5 Amps. Pump\'s rotary vanes were all intact and in goodcondition the last time used. Becker Model # 1439661. Last used in amedical facility (clean) and was for a backup system & hardlyever started. This pump is ultra durable, and heavy duty. If you everneed a rebuild kit for this model pump, there\'s another e-bay selleroffering them for $1840. Don\'t waste your money and buy a new vacuumpump for close to $12K plus tax.

I purchased this for apretty penny and was going to use for my CNC router\'s vacuum table,but we went in another direction.My loss is your gain.Thispump model is ideal for holding down whole sheets of plywood to thebed of a production CNC router table instead of using clamps, whichis a slow process. It\'s rated to pull 173 CFM as Becker\'s chart sayson their site.You also never have to worry about your CNCspindle colliding with a clamp and breaking bits.

Pump is currently on a halfpalette. Buyer either picks uplocally, or hires a freight company. This is located at a residentialaddress in San Francisco without a loading dock. A full size semitruck does not fit down my curvy street in SF. If the freight carriercan\'t bring a smaller truck to pick it up, I\'ve had good luck hiringa flat bed tow truck to take heavy equipment out of the neighborhood,then transfer onto an 18 wheeler at a parking lot nearby. Buyer coordinates. Get a quote at Freightquote.com Buyer pays all freight charges and arranges pickup from seller within 5 days. Pump weighs 580.lbs. Dimensions are 32\" high, 48\" long and 30\" wide.