ESOTERIC SOUND RE-EQUALIZER

Pre-1955 records were recorded to different standard than now employed in RIAA equalized phono amplifiers. The Re-Equalizer compensates for this. Easily installed thru the external tape monitor circuit or your preamplifier/receiver or via theSuperConnector.

\"If anything, I\'m as amazed by the Re-Equalizer\'s apparent noiselessness as by its obvious flexibility\"
Art Dudley, STEREOPHILE MAGAZINE, January, 2009\"The only thing to say about this is that it is a pity that I didn’t buy it long time ago. This piece of equipment is really necessary for playback of 78’s\"
Another satisfied customer

\"What have you done to me?! Now I have to listen to a few thousand 78s...over again to hear them right\"

And yet, another satisfied customer

On Stereophile Magazine List of Recommended Components

* Accurate reproduction from any source is accomplished by producing an accurate equalization difference curve to compensate the output of your RIAA phono preamp

* In \"BYPASS\" mode, the mono or stereo signal is hard-wired input to output - introduces absolutely no noise or distortion to anymodern audiophile unit.

* In “IN” mode, left and right are combined to mono, and phone compensationintroduced* Supplied with six pages of recommended compensation settings to accommodate any vintage
record - including acoustics. This is the most highly researched chart ever produced.

* For early dual-band and single groove stereo discs, two units are required. 20% off 2nd unit* Passive equalization design & film capacitors assure low TIM and transparent sound.* High input impedance for use with either tube or solid-state amplifier outputs.

* Connects to hifi systems like any ordinary graphic equalizer.* Works with phono, tape recorder outputs - any source.