I\'m selling my Garrett GTP30-67 Gas Turbine Engine and everything you need to make it run in a Polaris RZR. I replaced the RZR\'s original engine with a gas turbine connected to a custom gear-reduction box, which is then connected to a Eaton piston pump that controls a hydraulic motor and the transmission. The turbine runs a consistent 8,000 rpm at an output shaft mated to the gear-reduction box, which drops the rpm output to 3,650 (the speed required by the Eaton piston pump to which it\'s connected). The piston pump pressurizes the hydraulic fluid and is attached to the final part of the hydraulic drive, a Sunfab hydraulic motor. From there, a pulley mounted on the motor spins a three-inch-wide Gates transmission belt and a pulley connected to the input shaft of the RZR\'s stock gearbox. A control stick installed in a box between the seats runs the Sunfab motor and acts as a hand-controlled accelerator. Everything operates perfectly and I can fire it up and demo it to serious buyers. You get all the custom hoses, coolers- tons of custom parts...I can\'t sell you turbine installed in my RZR but you can place the system in yours... or a boat or a car...

---