Here we have one great sounding and looking McIntosh MC 2505 vintage solid state power amplifier made in Binghamton, New York. Recently serviced by Echo Audio here in Portland, Oregon. This amp is built like a tank and ready to roll, no problems whatsoever. I\'m going to pay to have it professionally packed by UPS so it will be insurable for the full purchase price (at no additional cost to the buyer).I would love to keep this guy, it sounds great and looks so cool, I especially love the big blue power meters; but sadly it must go.It\'s in very good condition cosmetically though it does have some flaws. There\'s a bit of bubbling on the face around the panloc buttons and headphones jack, a spot to the left of the left power meter and a tiny little bubble under the \"ER\" of \"POWER AMPLIFIER\" on the right side. On the top of the amp, the front left and rear left and right corners have some longer scratches that look to have been touched up with black paint. Also up top on the front right corner there are some scratches and a bit of the writing has been removed. Other than that there are various minor little scuffs and scratches here and there that would be typical for a vintage amp like this that isn\'t in mint, but very good condition. Please see the pics for more details.
Please ask any and all questions you may have, thanks.
On Aug-30-16 at 20:56:35 PDT, seller added the following information:
The McIntosh MC2505 is a solid state power amplifier with a maximum power output of 100 watts RMS continuous, 50 watts per channel operating simultaneously, into 4 ohm, 8 ohm, or 16 ohm loads.Harmonic distortion is less than 0.25% at rated power output from 20Hz to 20,000Hz.Frequency range at rated output both channels; +0, 0.025dB, 20Hz through output: 50 watts per channel into 8Ω (stereo)Frequency response: 20Hz to 20kHzTotal harmonic distortion: 0.25%Damping factor: 10Input sensitivity: 0.5VSignal to noise ratio: 90dBSpeaker load impedance: 4Ω to 16Ω
